To run Windows Diagnostic, you must reboot your PC with the disk or CD-ROM. After the reboot, Windows Diagnostic will load and its interface will appear. After loading, the first test pass will begin, using the default standard test suite, and continue until complete, unless Windows Diagnostic is either paused or exited. Once the first test pass is complete, Windows Diagnostic will begin a second test pass using the same settings as before. Windows Diagnostic will continue to run test passes until you exit.
Windows Diagnostic user interface is currently available only in English. However, you can still use the Windows Diagnostic tool on PCs configured to use languages other than English. To use Windows Diagnostic, your PC must have either a 3.5-inch floppy drive or CD-ROM drive. If Windows Diagnostic completes the first pass and reports no errors, then your RAM is probably working correctly. It is unlikely that Windows Diagnostic will find any errors with your RAM on subsequent passes using the same settings. If you want to test your RAM more completely, you can run the extended test suite by pressing T while Windows Diagnostic is running.
If Windows Diagnostic detects any errors with your RAM, the screen is updated with information about the error. If any test tests negative, it implies that your PC has hardware to be fixed. If Windows Diagnostic detects errors in your hardware, you should correct the errors and run Windows Diagnostic again until you get a report of no errors before you attempt to run Windows again. If this is not done, then Windows may not work properly. WindowsDiagnostics | “I couldn’t believe the number of errors and junk it found in my system! Thanks for great recommendation.”
]]>